SYMPTOM DIAGNOSTIC INDEX [SKYACTIV-G (E)]
id0103s48005s7
Diagnostic Index
|
TROUBLESHOOTING ITEM |
DESCRIPTION |
|
|---|---|---|
|
Blown fuses
|
• Fuse is damaged.
|
|
|
Check engine light illuminates
|
• Check engine light illuminates incorrectly.
|
|
|
Will not crank
|
• Starter does not work.
|
|
|
Hard to start/long crank/erratic start/erratic crank
|
• Starter cranks engine at normal speed but engine requires excessive cranking time before starting.
• Battery is operating normally.
|
|
|
Engine stalls-after start/at idle
|
• Stalling occurs if vehicle is left idling under no load.
• Stalling occurs when load (electric, A/C) is applied during idling.
• Stalling occurs if the accelerator pedal is depressed from an idling condition when accelerating from a stop.
|
|
|
Cranks normally but will not start
|
• Cranking occurs but no ignition.
|
|
|
Engine oil warning light illuminated/message related to engine hydraulic pressure malfunction indicated in display
|
• Engine oil warning light illuminated.
• Message related to engine hydraulic pressure malfunction indicated in display.
|
|
|
Low fuel warning light flashes/message related to low fuel level indicated in display
|
• The low fuel warning light flashes.
• A message related to a low fuel level is indicated in the display.
|
|
|
Engine runs rough/rolling idle
|
• Idle speed lower than the specification.
• Idling speed unstable, increases/decreases.
|
|
|
Fast idle/runs on
|
• Engine speed continues at fast idle after warm-up.
• Engine runs after ignition is switched off.
|
|
|
Low idle/stalls during deceleration
|
• Engine speed decreases when the accelerator pedal is released.
• Stalls during deceleration with the accelerator pedal fully released.
• When the accelerator pedal is fully released, vehicle stalls directly after vehicle stops.
|
|
|
Engine stalls/quits, engine runs rough, misses, buck/jerk, hesitation/stumble, surges
|
• Stalling occurs while driving with the throttle open.
|
|
|
Lack/loss of power-acceleration/cruise
|
• Engine speed increase delays when the accelerator pedal is fully depressed.
|
|
|
Knocking/pinging-acceleration/cruise
|
• Abnormal combustion occurs under the condition such as the temperature in the combustion chamber is too high resulting in abnormal noise.
• Knocking sound occurs from the engine compartment during acceleration.
|
|
|
Poor fuel economy
|
• The fuel consumption is high compared to the customer’s expectations or the previous fuel consumption.
|
|
|
Emission compliance
|
• Fails emissions test.
|
|
|
High oil consumption/leakage
|
• Oil consumption is excessive.
|
|
|
Cooling system concerns-overheating
|
• The engine coolant temperature is abnormally high.
|
|
|
Cooling system concerns-runs cold
|
• Engine does not reach normal operating temperature.
|
|
|
Exhaust smoke
|
• Blue, black, or white smoke from exhaust system.
|
|
|
Fuel odor (in engine compartment)
|
• Gasoline fuel smell or visible leakage.
|
|
|
Engine noise
|
• Engine noise from under hood.
|
|
|
Vibration concerns (engine)
|
• Vibration from under hood or driveline.
|
|
|
A/C does not work sufficiently
|
• A/C compressor magnetic clutch does not engage when A/C switch is turned on.
• Compressor valve inoperative
|
|
|
A/C is always on or A/C compressor runs continuously
|
• A/C compressor magnetic clutch does not disengage.
|
|
|
Sulfuric smell occurs
|
• Rotten egg smell (sulphur) from exhaust.
|
|
|
Spark plug condition
|
• Incorrect spark plug condition.
|
|
|
No cylinder deactivation
|
• Cylinder deactivation control does not operate.
|
|
|
ATX related troubleshooting item
|
||
|
i-stop related troubleshooting item
|
||