Home

Mazdamanuals.com

NEUTRAL SENSOR INSPECTION [SKYACTIV-D 1.8]

id0140s1813300

Voltage Inspection

Caution

• If the wiring harnesses or waterproof connectors are damaged, water penetrating the connector will cause a sensor malfunction. To prevent this, be careful not to damage wiring harnesses or waterproof connectors.

1. Lift up the vehicle.

2. Remove the front under cover No.2. (See FRONT UNDER COVER No.2 REMOVAL/INSTALLATION.)

3. Connect the voltmeter to neutral sensor No.1/No.2 terminal C (vehicle wiring harness side).

4. Verify that the neutral sensor voltage is within the standard when the shift lever is shifted with the ignition switched ON (engine off).

• If not as specified, replace the neutral sensor No.1/No.2. (See NEUTRAL SENSOR REMOVAL/INSTALLATION [C66M-R, C66MX-R].)

am3zzw00024018

Specification

Shift lever is at neutral position: Approx. 0.8 V or less

Shift lever is not at neutral position: Approx. 4.5 V or more