Mazdamanuals.com

TCM CONFIGURATION [ET6A-EL, ET6AX-EL]

Home  id0517n3119200

Note

•  The TCM is built into the control valve body.

1.  Verify TCM configuration implementation necessity for replacement parts.

Replacement part	Configuration necessity
Control valve body replacement	Necessary
Oil pressure switch replacement	Unnecessary
Automatic transaxle replacement	Necessary
ON/OFF solenoid replacement	Unnecessary
Coupler component replacement	Unnecessary

2.  To replace the control valve body or automatic transaxle, perform the following procedure.

(1)  Connect the M-MDS to the DLC-2.

(2)  Switch the ignition ON (engine off).

(3)  Activate the M-MDS and perform the following procedure.

1)  Press [Start] to start the vehicle identification.

2)  Press the [Toolbox] tab.

3)  Press the [Work Support] icon.

4)  Press [Configuration].

5)  Press [Run] to perform the configuration.

6)  Press [TCM].

7)  When [Install the new ECU] is displayed, move to the control valve body or automatic transaxle replacement procedure.

3.  If the control valve body or automatic transaxle is replaced, perform the following procedure.

(1)  Return to the M-MDS operation and press [Continue].

(2)  When the M-MDS processing is completed, press [Next].

(3)  When the M-MDS processing is completed, press [Next].

(4)  Verify that the following conditions/operations are met/completed, mark the check boxes, and then press [Next].

•  Ignition is switched ON (engine off)

•  Install battery charger to vehicle

•  Battery voltage: 11.6 V or more

•  Connect power cable to M-MDS

•  Front doors on both sides and liftgate are open

(5)  Press [Finish].

(6)  Switch the ignition OFF.

(7)  Switch the ignition ON (engine off) to complete global central configuration (GCC) for the control valve body or automatic transaxle.

(8)  Clear the DTC. (See CLEARING DTC.)