Home

Mazdamanuals.com

PID/DATA MONITOR TABLE [SAS CONTROL MODULE (STANDARD DEPLOYMENT CONTROL SYSTEM)]

PID/DATA MONITOR TABLE [SAS CONTROL MODULE (STANDARD DEPLOYMENT CONTROL SYSTEM)]

 id0802g7012800

Note
•  The SRS air bag system can be identified by whether or not the seat track position sensor is present.
―  Standard deployment control system: Without seat track position sensor
―  Two-step deployment control system: With seat track position sensor

PID name (definition)

Unit/Operation

Operation status (reference)
AB_RES_F_C
(Passenger-side front center air bag module resistance nominal)
ohm
Note
•  Displays in the M-MDS but it does not operate.
AB_RES_F_D
(Driver-side air bag module (inflator No.1) resistance nominal)
ohm
Continuous: 0.99—6.42 ohms
AB_RES_F_P
(Passenger-side air bag module (inflator No.1) resistance nominal)
ohm
Continuous: 0.81—6.42 ohms
AB2_RES_F_D
(Driver-side air bag module (inflator No.2) resistance nominal)
ohm
Continuous: 0.99—6.42 ohms
AB2_RES_F_P
(Passenger-side air bag module (inflator No.2) resistance nominal)
ohm
Continuous: 0.81—6.42 ohms
C_AB_RES_D
(Driver-side curtain air bag module resistance nominal)
ohm
Continuous: 0.81—6.42 ohms
C_AB_RES_P
(Passenger-side curtain air bag module resistance nominal)
ohm
Continuous: 0.81—6.42 ohms
DETECT_BAR_RES_A
(Poorly connected detector bar terminals resistance nominal (SAS control module connector No.1))
ohm
•  Normal connected: 100 ohm or less
•  Poor connected: 10 kilohm or more
DETECT_BAR_RES_B
(Poorly connected detector bar terminals resistance nominal (SAS control module connector No.2))
ohm
•  Normal connected: 100 ohm or less
•  Poor connected: 10 kilohm or more
DETECT_BAR_RES_C
(Poorly connected detector bar terminals resistance nominal (SAS control module connector No.3))
ohm
•  Normal connected: 100 ohm or less
•  Poor connected: 10 kilohm or more
DTC_STAT
(Number of malfunction detections)
―
Number of malfunction detections
FAR_SIDE_AB_RES
(Far-side air bag module)
ohm
Note
•  Displays in the M-MDS but it does not operate.
K_AB_RES_D
(Driver-side knee air bag module resistance nominal)
ohm
Continuous: 0.81—9.85 ohms
K_AB_RES_P
(Passenger-side knee air bag module resistance nominal)
ohm
Continuous: 0.81—9.85 ohms
LAP_PRETEN_RES_D
(Driver-side lap pre-tensioner seat belt resistance nominal)
ohm
Note
•  Displays in the M-MDS but it does not operate.
LAP_PRETEN_RES_P
(Passenger-side lap pre-tensioner seat belt resistance nominal)
ohm
Note
•  Displays in the M-MDS but it does not operate.
OCS_CAL_STAT
(Seat weight sensor control module calibration status)
Process started/Normally ended/Failure caused by other command process/Failure caused by abnormal voltage/Failure caused by abnormal measured weight/Fault that depends on over the limit of OCS sensors/Failure caused by timeout/In process/Failed to start/Failure caused by OCS fault
Indicates seat weight sensor control module calibration status
OCS_DTC_STAT
(Seat weight sensor control module DTC cleared status)
Process Started/Normally ended/In process/Failed to start/Abnormal end
Note
•  Displays in the M-MDS but it does not operate.
OCS_STAT
(Occupant classification status)
Empty/Below Threshold (Small)/Indeterminate/Above Threshold (Large)
Occupant classification status determined by seat weight sensor
R_PRETEN_RES_D
(Driver-side rear pre-tensioner seat belt resistance nominal)
ohm
Continuous: 0.81—6.42 ohms
R_PRETEN_RES_P
(Passenger-side rear pre-tensioner seat belt resistance nominal)
ohm
Continuous: 0.81—6.42 ohms
S_AB_RES_D
(Driver-side side air bag module resistance nominal)
ohm
Continuous: 0.81—9.85 ohms
S_AB_RES_P
(Passenger-side side air bag module resistance nominal)
ohm
Continuous: 0.81—9.85 ohms
S_BELT_PRETEN_RES_D
(Driver-side front pre-tensioner seat belt resistance nominal)
ohm
Continuous: 0.81—6.42 ohms
S_BELT_PRETEN_RES_P
(Passenger-side front pre-tensioner seat belt resistance nominal)
ohm
Continuous: 0.81—6.42 ohms
S_BELT_STAT_D
(Driver-side buckle switch status)
Unbuckled/Buckled
•  Driver-side front seat belt fastened (Driver-side buckle switch off): Buckled
•  Driver-side front seat belt not fastened (Driver-side buckle switch on): Unbuckled
S_BELT_STAT_P
(Passenger-side buckle switch status)
Unbuckled/Buckled
•  Passenger-side front seat belt fastened (Passenger-side buckle switch off): Buckled
•  Passenger-side front seat belt not fastened (Passenger-side buckle switch on): Unbuckled
SEAT_TRACK_SEN
(Seat track position sensor state)
Rearward/Forward
•  Driver's seat is at the most forward position: Forward
•  Others: Rearward
SEAT_TRACK_STAT
(Seat track position sensor malfunction status)
No Fault/Fault
•  Seat track position sensor is normal: No Fault
•  Seat track position sensor is malfunctioning: Fault
SEAT_WEIGHT_P
(Weight of an occupant on the front passenger’s seat)
Kg
Indicate weight of an occupant on the front passenger’s seat
VPWR
(SAS control module power voltage)
V
Ignition switch is at ON: IG1 voltage
WRNG_LAMP_STAT
(Air bag system warning light status)
Lamp Off/Lamp On/Lamp Flash at 5 HZ/Plant Mode/Status Unknown
•  Air bag system warning light off: Lamp_Off
•  Air bag system warning light on: Lamp_On
•  Air bag system warning light flashing: Plant_Mode
•  Air bag system warning light flashing: Lamp Flash at 5 HZ
•  Air bag system warning light flashing in plant mode: Plant_Mode
•  Air bag system warning light status unrecognized: Unknown