PID/DATA MONITOR TABLE [ELECTRICAL SUPPLY UNIT (ESU) (E)]
id0902ff1205fh
PID |
Unit/Operation |
Data contents |
Module control terminal |
---|---|---|---|
AUTO_HOLD_IND
|
Off/On
|
• Off: AUTOHOLD stand-by indicator light turns off.
• On: AUTOHOLD stand-by indicator light turns on.
|
1S
|
AUTO_HOLD_SW
|
Off/On
|
• Off: AUTOHOLD switch is off.
• On: AUTOHOLD switch is on.
|
1U
|
B2_VOLT
|
V
|
Displays voltage at electrical supply unit (ESU) terminal 5C (power supply)
|
5C
|
B7_VOLT
|
V
|
Displays voltage at electrical supply unit (ESU) terminal 4H (power supply)
|
4H
|
BACK_UP_VOLT
|
V
|
Displays intermediate voltage of back-up power supply.
|
5G
|
BGLR_HORN*1
|
Off/On
|
• Off: Theft-deterrent horn is not operated.
• On: Theft-deterrent horn is operated.
|
2D
|
BRK_SW
|
Off/On
|
• Off: Brake switch (No.1 signal) is off.
• On: Brake switch (No.1 signal) is on.
|
5D
|
CARGO_LAMP_STAT
|
OFF/ON/Fail(Circuit Short to GND)
|
• OFF: Cargo compartment light does not illuminate.
• ON: Cargo compartment light illuminates.
• Fail(Circuit Short to GND): Short to ground in cargo compartment light circuit is detected.
|
5I
|
CARGO_SW
|
Close/Open
|
• Close: Liftgate is close.
• Open: Liftgate is open.
|
3H
|
CLOSED_FUEL_TANK
|
OFF/ON
|
• OFF: Sealed tank is not equipped.
• ON: Sealed tank is equipped.
|
3C, 3A, 1W, 1X
|
COUPLING_TEMP_SEN*2
|
°C, °F
|
Displays oil temperature of coupling component.
|
1E, 1G
|
DOOR_SW_L/F
|
Close/Open
|
• Close: Front door (LH) is closed.
• Open: Front door (LH) is open.
|
5J
|
DOOR_SW_L/R
|
Close/Open
|
• Close: Rear door (LH) is closed.
• Open: Rear door (LH) is open.
|
5L
|
E_LATCH_MOTOR*3
|
Not Drive/Drive
|
• Not Drive: Liftgate latch and lock actuator is not operated.
• Drive: Liftgate latch and lock actuator is operated.
|
4G
|
FUEL_LID_LCK_REQ
|
Not Drive/Lock/UnLock
|
• Not Drive: All door lock signal and all door unlock signal are not received.
• Lock: All door lock signal is received.
• UnLock: All door unlock signal is not received.
|
3C, 3A, 1W, 1X
|
FUEL_LID_MOTOR_L
|
OFF/ON
|
• OFF: Fuel-filler lid lock actuator is not operated to lock.
• ON: Fuel-filler lid lock actuator is operated to lock.
|
—
|
FUEL_LID_MOTOR_STAT
|
Not Drive/Lock/UnLock
|
• Not Drive: Fuel-filler lid lock actuator motor is not operated.
• Lock: Fuel-filler lid lock actuator motor perform a lock operation.
• UnLock: Fuel-filler lid lock actuator motor perform a unlock operation.
|
—
|
FUEL_LID_MOTOR_UL
|
OFF/ON
|
• OFF: Fuel-filler lid lock actuator is not operated to unlock.
• ON: Fuel-filler lid lock actuator is operated to unlock.
|
—
|
FUEL_LID_SW
|
|
||
FUEL_LID_ULCK_REQ
|
OFF/ON
|
• OFF: All door unlock signal is not received.
• ON: All door unlock signal is received.
|
3C, 3A, 1W, 1X
|
FUEL_SEN_MAIN_GAUGE
|
—
|
Displays the fuel gauge
|
1J, 1F
|
FUEL_SEN_SUB_GAUGE*2
|
—
|
Displays the fuel gauge (sub)
|
1J, 1F
|
FUEL_SEN_VOLT
|
—
|
Fuel gauge sender unit voltage
|
5P, 5C
|
IG1_VOLT
|
V
|
Displays voltage at electrical supply unit (ESU) terminal 5K (ignition power supply)
|
5K
|
LID_STOP_LAMP
|
Off/On
|
• Off: Liftgate light is turned off.
• On: Liftgate light is turned on.
|
5O
|
OIL_TEMP_SEN*2
|
°C, °F
|
Displays rear differential oil temperature.
|
1I, 1K
|
PARK_BRK_SW
|
|
||
R_FOG_REQ
|
Off/On
|
• Off: Rear fog light on request signal is not received.
• On: Rear fog light on request signal is received.
|
3C, 3A, 1W, 1X
|
R_FOG_STAT
|
Off/On
|
• Off: Rear fog light is turned off.
• On: Rear fog light is turned on.
|
5S
|
R_TURN_STAT_L
|
Off/On
|
• Off: Rear turn light (LH) is turned off.
• On: Rear turn light (LH) is turned on.
|
4D
|
R_TURN_STAT_R
|
Off/On
|
• Off: Rear turn light (RH) is turned off.
• On: Rear turn light (RH) is turned on.
|
4B
|
R_WIP_AUTO_STOP_SW
|
Parking Pos/Not Parking Pos
|
• Parking Pos: Auto stop switch is on.
• Not Parking Pos: Auto stop switch is off.
|
3D
|
R_WIP_STAT
|
Off/On
|
• Off: Rear wiper is not operated.
• On: Rear wiper is operated.
|
4J
|
REV_LAMP_CTRL_STAT
|
Off/On/Unknown/Fault
|
• Off: Back-up light on signal is not sent from relectrical supply unit (ESU).
• On: Back-up light on signal is sent from electrical supply unit (ESU).
• Unknown: Back-up light on signal is not determined.
• Fault: Error signals is received from body control module (BCM).
|
3C, 3A, 1W, 1X
|
REV_LAMP_STAT
|
Off/On
|
• Off: Back-up lights are not illuminated.
• On: Back-up lights are illuminated.
|
5O
|
S_BELT_STAT_C/R
|
Not insert/Insert
|
• Not insert: Rear center buckle switch is on.
• Insert: Rear center buckle switch is off.
|
1O
|
S_BELT_STAT_L/3RD
|
|
||
S_BELT_STAT_L/R
|
Not insert/Insert
|
• Not insert: Rear buckle switch (LH) is on.
• Insert: Rear buckle switch (LH) is off.
|
1Q
|
S_BELT_STAT_R/3RD
|
|
||
S_BELT_STAT_R/R
|
Not insert/Insert
|
• Not insert: Rear buckle switch (RH) is on.
• Insert: Rear buckle switch (RH) is off.
|
1M
|
SEAT_SEN_C/3RD
|
|
||
SEAT_SEN_C/R
|
|
||
SEAT_SEN_L/3RD
|
|
||
SEAT_SEN_L/R
|
|
||
SEAT_SEN_R/3RD
|
|
||
SEAT_SEN_R/R
|
|
||
SOL_CUR*2
|
A
|
Displays the current of the AWD solenoid.
|
2B, 2C
|
STOP_LAMP_STAT
|
Off/On
|
• Off: High-mount brake light is turned off.
• On: High-mount brake light is turned on.
|
5B, 3B
|
T/LGT_REQ
|
OFF/ON
|
• OFF: Liftgate release signal is not received.
• ON: Liftgate release signal is received.
|
3C, 3A, 1W, 1X
|
TAIL_LAMP_STAT
|
Off/On
|
• Off: Taillights are not illuminated.
• On: Taillights are illuminated.
|
5R
|
TNS_LAMP_STAT
|
Off/On
|
• Off: TNS (parking lights) is turned off.
• On: TNS (parking lights) is turned on.
|
5E
|
TOWBAR_SW
|
Off/On
|
|
3N
|
TOWING_SW
|
Off/On
|
|
3M
|
VPWR
|
V
|
Displays voltage at electrical supply unit (ESU) terminal 5P (power supply)
|
5P
|