Mazdamanuals.com

SEAT POSITION INITIAL LEARNING

id091300872400

1.  Connect the M-MDS to the DLC-2.

2.  Switch the ignition ON (engine off).

3.  Activate the M-MDS and perform the following procedure.

(1)  Press [Start] to start the vehicle identification.

(2)  Press the [Toolbox] tab.

(3)  Press the [Work Support] icon.

(4)  Press [SEATS].

(5)  Press [Run] for [Calibrating Driving Position].

(6)  Confirm the Calibrating Driving Position procedure from Step (7) to Step (12), and press [Next].

(7)  Verify that the ignition is switched ON (engine off) and press [Next].

Note

•  When operating the power seat switch, hold the switch for 1 s or more after the seat position movement stops.

(8)  Operate the power seat switch and move the seat position to the following conditions.

•  Slide rear end

•  Tilt lower end

•  Lift lower end

(9)  When Step (8) is completed, press [Next].

Note

•  When operating the power seat switch, hold the switch for 1 s or more after the seat position movement stops.

(10)  Operate the power seat switch and move the seat position to the following conditions.

•  Slide front end

•  Tilt upper end

•  Lift upper end

(11)  When Step (10) is completed, press [Next].

(12)  Press [Next] to complete [Calibrating Driving Position].