Home

Mazdamanuals.com

 DTC P1589 [MZR-CD (RF Turbo)]

DTC P1589 [MZR-CD (RF Turbo)]

id0102f1118000

DTC P1589

Intake shutter valve control range/performance

DETECTION CONDITION

• The PCM compares the actual intake shutter valve with the target intake shutter valve when the engine is running. If the difference is more than 4.2 ° and less than - 4.2 °, the PCM determines that there is a intake shutter valve control circuit range/performance problem.
Diagnostic support note
• The MIL illuminates if the PCM detects the above malfunction condition in the first drive cycle.
• FREEZE FRAME DATA is available.
• DTCs are stored in the PCM memory.

POSSIBLE CAUSE

• Intake shutter valve malfunction
• PCM malfunction

Diagnostic procedure

STEP

INSPECTION

ACTION

1
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
• Has FREEZE FRAME DATA been recorded?
Yes
Go to the next step.
No
Record FREEZE FRAME DATA on repair order, then go to the next step.
2
VERIFY RELATED REPAIR INFORMATION AVAILABILITY
• Check for related Service Bulletins and/or on-line repair information availability.
• Is any related repair information available?
Yes
Perform repair or diagnosis according to the available repair information.
• If the vehicle is not repaired, go to the next step.
No
Go to the next step.
3
INSPECT FOR OTHER DTCS
• Have other DTCs been stored?
Yes
Perform the diagnostic procedure for the applicable DTCs.
No
Go to the next step.
4
INSPECT INTAKE SHUTTER VALVE
• Inspect the intake shutter valve.
• Is there any malfunction?
Yes
Replace the intake shutter valve, then go to the next step.
No
Go to the next step.
5
VERIFY TROUBLESHOOTING OF P1589 COMPLETED
• Make sure to reconnect all disconnected connectors.
• Clear the DTC from the PCM memory using the WDS or equivalent.
• Turn the engine switch off.
• Start the engine and let it idle.
• Is the same DTC present?
Yes
Replace the PCM, then go to the next step.
No
Go to the next step.
6
VERIFY AFTER REPAIR PROCEDURE
• Perform the "After Repair Procedure".
• Are any DTCs present?
Yes
Go to the applicable DTC inspection.
No
Troubleshooting completed.