|
STEP
|
INSPECTION
|
ACTION
|
|
1
|
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
• Has FREEZE FRAME DATA been recorded?
|
Yes
|
Go to the next step.
|
|
No
|
Record the FREEZE FRAME DATA on the repair order, then go to the next step.
|
|
2
|
VERIFY RELATED REPAIR INFORMATION AVAILABILITY
• Verify related service repair information availability.
• Is any related repair information available?
|
Yes
|
Perform repair or diagnosis according to the available repair information.
• If the vehicle is not repaired, go to the next step.
|
|
No
|
Go to the next step.
|
|
3
|
VERIFY FUEL INJECTOR COMPENSATION DATA INPUTTED PROPERLY
• Perform the fuel injector compensation data input procedure.
• Does the inputted fuel injector compensation data properly?
|
Yes
|
Go to the next step.
|
|
No
|
Clear the learning data on PCM. Perform the fuel injector compensation data input procedure again.
|
|
4
|
VERIFY TROUBLESHOOTING OF DTC P1676 COMPLETED
• Make sure to reconnect all disconnected connectors.
• Turn the engine switch to ON position (engine off).
• Clear the DTC from PCM memory using the WDS or equivalent.
• Start the engine.
• Is the same DTC present?
|
Yes
|
Replace the PCM, then go to the next step.
|
|
No
|
Go to the next step.
|
|
5
|
VERIFY AFTER REPAIR PROCEDURE
• Perform "AFTER REPAIR PROCEDURE".
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
|
|
No
|
Troubleshooting completed.
|