|
STEP
|
INSPECTION
|
ACTION
|
|
1
|
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
• Has FREEZE FRAME DATA been recorded?
|
Yes
|
Go to the next step.
|
|
No
|
Record the FREEZE FRAME DATA on the repair order, then go to the next step.
|
|
2
|
VERIFY RELATED REPAIR INFORMATION AVAILABILITY
• Verify related service repair information availability.
• Is any related repair information available?
|
Yes
|
Perform repair or diagnosis according to the available repair information.
• If the vehicle is not repaired, go to the next step.
|
|
No
|
Go to the next step.
|
|
3
|
IDENTIFY TRIGGER DTC FOR FREEZE FRAME DATA
• Is DTC P1196 on FREEZE FRAME DATA?
|
Yes
|
Go to the next step.
|
|
No
|
Go to troubleshooting procedures for DTC in FREEZE FRAME DATA.
|
|
4
|
INSPECT PCM CONTROL RELAY CONNECTOR FOR POOR CONNECTION
• Turn the engine switch off.
• Disconnect the PCM control relay connector.
• Inspect for poor connection (such as damaged/pulled-out pins, and corrosion).
• Is there any malfunction?
|
Yes
|
Repair or replace terminal, then go to Step 7.
|
|
No
|
Go to the next step.
|
|
5
|
INSPECT PCM CONTROL RELAY
• Inspect the PCM control relay.
• Is it normal?
|
Yes
|
Go to the next step.
|
|
No
|
Install the sensor securely, then go to the Step 7.
|
|
6
|
INSPECT PCM CONTROL RELAY CIRCUIT FOR SHORT TO POWER SUPPLY
• Turn the engine switch to the ON position (Engine off).
• Measure voltage between PCM control relay terminal C (wiring harness-side) and body ground.
• Is the voltage B+?
|
Yes
|
Repair or replace for short to power supply.
Then, go to the next step.
|
|
No
|
Go to the next step.
|
|
7
|
VERIFY TROUBLESHOOTING OF DTC P1196 COMPLETED
• Make sure to reconnect all disconnected connectors.
• Turn the engine switch to the ON position (Engine off).
• Clear the DTC from the PCM memory using the WDS or equivalent.
• Start the engine.
• Perform the OBD DRIVE MODE.
• Is the same DTC present?
|
Yes
|
Replace the PCM, go to the next step.
|
|
No
|
Go to the next step.
|
|
8
|
VERIFY AFTER REPAIR PROCEDURE
• Perform the Repair Verification Drive Mode.
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
|
|
No
|
Troubleshooting completed.
|
