NEUTRAL SWITCH INSPECTION [MZR-CD (RF Turbo)]

Note

• Perform the following test only when directed.

Continuity Inspection

1. Disconnect the negative battery cable.

2. Remove the neutral switch. (See NEUTRAL SWITCH REMOVAL/INSTALLATION [A26M-R])

3. Inspect for continuity between the neutral switch terminals using an ohmmeter.

• If the neutral switch is okay, perform the "Circuit Open/Short Inspection"

• If not as specified, replace the neutral switch. (See NEUTRAL SWITCH REMOVAL/INSTALLATION [A26M-R])

Specification

Circuit Open/Short Inspection

1. Disconnect the PCM connector. (See PCM REMOVAL/INSTALLATION [MZR-CD (RF Turbo)])

2. Inspect for open/short circuit in the following wiring harnesses.

• If there is open/short circuit, repair or replace wiring harnesses.

Open circuit

• Neutral switch terminal A and PCM terminal 110

• Neutral switch terminal B and body ground

Short circuit

• Neutral switch terminal A and body ground

• Neutral switch terminal A and power supply

• Neutral switch terminal B and power supply