|
DTC |
B2477 |
Module configuration |
|
|
DETECTION CONDITION |
• Configuration write failure is detected
|
||
|
POSSIBLE CAUSE |
• Module configuration procedure is not done properly.
|
||
Diagnostic procedure
|
STEP
|
INSPECTION
|
ACTION
|
|
|---|---|---|---|
|
1
|
CHECK WHETHER ABS (ABS/TCS) HU/CM IS CONFIGURED
• Is ABS (ABS/TCS) HU/CM configured?
|
Yes
|
Go to the next step.
|
|
No
|
Configurate ABS (ABS/TCS) using the WDS or equivalent.
|
||
|
2
|
VERIFY TROUBLESHOOTING COMPLETED
• Clear the DTC from the memory.
(See Clearing DTCs Procedures)
• Is same DTC present?
|
Yes
|
Replace ABS (ABS/TCS) HU/CM, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
3
|
VERIFY AFTER REPAIR PROCEDURE
• Is there any other DTC present?
|
Yes
|
Go to the applicable DTC inspection.
(See DTC Table.)
|
|
No
|
Troubleshooting completed.
|
||