Home

Mazdamanuals.com

REVOLUTION SENSOR INSPECTION [SKYACTIV-D 1.8]

id0140s1446600

Voltage Inspection

Caution

• If the wiring harnesses or waterproof connectors are damaged, water penetrating the connector will cause a sensor malfunction. To prevent this, be careful not to damage wiring harnesses or waterproof connectors.

1. Lift up the vehicle.

2. Remove the front under cover No.2. (See FRONT UNDER COVER No.2 REMOVAL/INSTALLATION.)

3. Measure the output voltage wave pattern between revolution sensor terminals A and B using an oscilloscope.

• If not as specified, replace the revolution sensor. (See REVOLUTION SENSOR REMOVAL/INSTALLATION [C66M-R, C66MX-R].)

am3zzw00024015

• Specification

4.5 V or more (Maximum value of wave pattern)

0.8 V or less (Minimum value of wave pattern)

Wave pattern (reference)

am3zzw00024016

Oscilloscope setting

• 2 V/DIV (Y), 5 ms/DIV (X), DC range

Vehicle condition

• Idle (after warm up)

am3zzw00024017

Oscilloscope setting

• 2 V/DIV (Y), 5 ms/DIV (X), DC range

Vehicle condition

• Racing (Engine speed: 2,000 rpm)