Home

Mazdamanuals.com

POWER BRAKE UNIT VACUUM SENSOR INSPECTION [SKYACTIV-G (WITH CYLINDER DEACTIVATION (E))]

POWER BRAKE UNIT VACUUM SENSOR INSPECTION [SKYACTIV-G (WITH CYLINDER DEACTIVATION (E))]

 id0140u3889400

Note
•  The power brake unit vacuum sensor cannot be removed because it is integrated with the power brake unit.

Without Mazda M Hybrid


Function inspection

1.  Connect the M-MDS to the DLC-2.

2.  Switch the ignition ON (engine off).

3.  Display the PIDs BRK_BSTR_PRES_VOLT and BRK_BSTR_PRES_ACT. (See PID/DATA MONITOR INSPECTION.)

4.  Compare the voltage and wer brake unit vacuum indications for the PIDs BRK_BSTR_PRES_VOLT and BRK_BSTR_PRES_ACT with the standard in the table indicated below.

•  If they match the standard, perform the voltage inspection. (See Voltage inspection.)

Standard

BRK_BSTR_PRES_VOLT

BRK_BSTR_PRES_ACT

V

kPa {kgf/cm2, psi}
Approx. 0.4
10 {0.10, 1.5}
Approx. 4.65
115 {1.17, 16.7}


Voltage inspection

1.  Connect the M-MDS to the DLC-2.

2.  Switch the ignition ON (engine off).

3.  Verify that the power brake unit vacuum sensor output voltage (PID: BRK_BSTR_PRES_VOLT) is within the specification. (See PID/DATA MONITOR INSPECTION.)

•  If not within the specification, replace the power brake unit. (See POWER BRAKE UNIT REMOVAL/INSTALLATION [L.H.D. (E)].) (See POWER BRAKE UNIT REMOVAL/INSTALLATION [R.H.D.].)

Specification

ac5wzw00009761