Home

Mazdamanuals.com

DTC C0022:56 [DSC HU/CM]

DTC C0022:56 [DSC HU/CM]


 id040262003400


Outline

System malfunction location

DSC HU/CM (internal malfunction)

Detection condition
•  The DSC HU/CM detects a mismatch between the calibration data of the inlet solenoid valve stored in the internal memory and the calibration data of the inlet solenoid valve which was initialized when the ignition was switched ON (engine off or on).
Fail-safe
Refer to “DTC Table” and “Fail-safe Function Malfunction Contents Table”.(See DTC TABLE [DSC HU/CM (E)].)
Possible cause
•  DSC HU/CM internal malfunction
System wiring diagram
Not applicable
Connector diagram
Not applicable


Diagnostic Procedure

Step

Inspection

Results

Action

1
INSPECT DSC HU/CM FOR MALFUNCTION DEPENDING ON REPEATABILITY
•  Clear the DTC recorded in the memory.
•  Perform the DTC inspection for the DSC HU/CM.
•  Is the same Pending DTC present?
Yes
Replace the DSC HU/CM and perform the repair completion verification.
No
Go to the next step.
Repair completion verification
VERIFY IF OTHER DTCs DISPLAYED
•  Perform the DTC inspection.
•  Are any DTCs displayed?
Yes
Repair the malfunctioning location according to the applicable DTC troubleshooting.
No
DTC troubleshooting completed.