DTC C006B:00 [DSC HU/CM]
id040262005400
Outline
|
System malfunction location |
TCS/DSC control system |
||||
|---|---|---|---|---|---|
|
Detection condition
|
• DSC control continues for a specified period of time or more.
|
||||
|
Fail-safe
|
Refer to “DTC Table” and “Fail-safe Function Malfunction Contents Table”.(See DTC TABLE [DSC HU/CM (E)].)
|
||||
|
Possible cause
|
• This does not indicate a malfunction since constant TCS or DSC control over an extended period of time is inhibited to protect the DSC solenoid valve inside the DSC HU/CM.
|
||||
|
System wiring diagram
|
Not applicable
|
||||
|
Connector diagram
|
Not applicable
|
||||
Diagnostic Procedure
|
Step |
Inspection |
Results |
Action |
|---|---|---|---|
|
1
|
INSPECT DSC HU/CM FOR MALFUNCTION DEPENDING ON REPEATABILITY
• Clear the DTC recorded in the memory.
(See CLEARING DTC.)
• Perform the DTC inspection for the DSC HU/CM.
(See DTC INSPECTION.)
• Is the same Pending DTC present?
|
Yes
|
Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error.
If the CAN communication is normal, replace the DSC HU/CM and perform the repair completion verification.
|
|
No
|
Go to the next step.
|
||
|
Repair completion verification
|
VERIFY IF OTHER DTCs DISPLAYED
• Perform the DTC inspection.
(See DTC INSPECTION.)
• Are any DTCs displayed?
|
Yes
|
Repair the malfunctioning location according to the applicable DTC troubleshooting.
|
|
No
|
DTC troubleshooting completed.
|