DTC C0594:71 [ELECTRONICALLY CONTROLLED BRAKE UNIT]
id0402c6018900
Outline
|
System malfunction location |
Linear actuator |
||||
|---|---|---|---|---|---|
|
Detection condition
|
• The electronically controlled brake unit detects that the linear actuator is stuck.
|
||||
|
Fail-safe
|
Refer to “DTC Table” and “Fail-safe Function Malfunction Contents Table”. (See DTC TABLE [ELECTRONICALLY CONTROLLED BRAKE UNIT].)
|
||||
|
Possible cause
|
• Vehicle is used in cold region
• Brake fluid deterioration
• Electronically controlled brake unit malfunction
|
||||
|
System wiring diagram
|
Not applicable
|
||||
|
Connector diagram
|
Not applicable
|
||||
Diagnostic Procedure
|
Step |
Inspection |
Results |
Action |
|---|---|---|---|
|
1
|
VERIFY IF TEMPORARY MALFUNCTION IS DUE TO DRIVING CONDITIONS
• Clear the DTC recorded in the memory.
(See CLEARING DTC.)
• Perform the DTC inspection for the electronically controlled brake unit.
(See DTC INSPECTION.)
• Is the same Pending DTC present?
|
Yes
|
Go to the next step.
|
|
No
|
The system is normal. (Explain to the customer that as a result of driving the vehicle in a cold region with the brake fluid deteriorated, moisture in the brake fluid temporarily froze, and then go to the next step.)
|
||
|
2
|
VERIFY BRAKE FLUID DETERIORATION
• Visually inspect the color of the brake fluid.
• Is the color of the brake fluid nearly transparent?
|
Yes
|
Go to the next step.
|
|
No
|
Perform air bleeding after adding new brake fluid, and then perform the repair completion verification.
|
||
|
Repair completion verification 1
|
VERIFY THAT VEHICLE IS REPAIRED
• Clear the DTC recorded in the memory.
(See CLEARING DTC.)
• Perform the DTC inspection for the electronically controlled brake unit.
(See DTC INSPECTION.)
• Is the same Pending DTC present?
|
Yes
|
Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error.
If the CAN communication is normal, perform the diagnosis from Step 1.
• If the malfunction recurs, replace the electronically controlled brake unit, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
Repair completion verification 2
|
VERIFY IF OTHER DTCs DISPLAYED
• Perform the DTC inspection.
(See DTC INSPECTION.)
• Are any DTCs displayed?
|
Yes
|
Repair the malfunctioning location according to the applicable DTC troubleshooting.
|
|
No
|
DTC troubleshooting completed.
|