DTC U0300:51 [ELECTRONICALLY CONTROLLED BRAKE UNIT]
id0402c6022500
Outline
|
System malfunction location |
Internal control module software incompatibility |
||||
|---|---|---|---|---|---|
|
Detection condition
|
• The electronically controlled brake unit detects that software incompatible with the hardware specification was written
|
||||
|
Fail-safe
|
Refer to “DTC Table” and “Fail-safe Function Malfunction Contents Table”. (See DTC TABLE [ELECTRONICALLY CONTROLLED BRAKE UNIT].)
|
||||
|
Possible cause
|
• Writing of software incompatible with hardware specification for electronically controlled brake unit implemented
• Electronically controlled brake unit internal malfunction
|
||||
|
System wiring diagram
|
Not applicable
|
||||
|
Connector diagram
|
Not applicable
|
||||
Diagnostic Procedure
|
Step |
Inspection |
Results |
Action |
|---|---|---|---|
|
1
|
INSPECT ELECTRONICALLY CONTROLLED BRAKE UNIT FOR MALFUNCTION DEPENDING ON REPEATABILITY
• Install/connect the part removed/disconnected during the troubleshooting procedure.
• Clear the DTC recorded in the memory.
(See CLEARING DTC.)
• Perform the DTC inspection for the electronically controlled brake unit.
(See DTC INSPECTION.)
• Is the same Pending DTC present?
|
Yes
|
Replace the electronically controlled brake unit and perform the repair completion verification.
|
|
No
|
Go to the next step.
|
||
|
Repair completion verification
|
VERIFY IF OTHER DTCs DISPLAYED
• Perform the DTC inspection.
(See DTC INSPECTION.)
• Are any DTCs displayed?
|
Yes
|
Repair the malfunctioning location according to the applicable DTC troubleshooting.
|
|
No
|
DTC troubleshooting completed.
|