Home

Mazdamanuals.com

OFF-ROAD TRACTION ASSIST SWITCH INSPECTION [WITH OFF-ROAD TRACTION ASSIST]

OFF-ROAD TRACTION ASSIST SWITCH INSPECTION [WITH OFF-ROAD TRACTION ASSIST]

 id0415008039f2

Note
•  The OFF-ROAD TRACTION ASSIST switch is integrated with the cluster switch No.1.
•  For the OFF-ROAD TRACTION ASSIST switch removal/installation, refer to CLUSTER SWITCH REMOVAL/INSTALLATION. (See CLUSTER SWITCH REMOVAL/INSTALLATION.)

1.  Disconnect the negative battery terminal.(See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION [(E)].)

2.  Disconnect the cluster switch No.1 connector. (See CLUSTER SWITCH REMOVAL/INSTALLATION.)

3.  Attach the tester lead to the cluster switch No.1 wiring harness-side connector and inspect voltage or continuity according to the Terminal Voltage Table (Reference) on the table.

•  If not as specified, repair or replace the related wiring harness.
•  If as specified, replace the cluster switch No.1. (See CLUSTER SWITCH REMOVAL/INSTALLATION.)


Terminal Voltage Table (Reference)

am3zzw00034533

—: Not applicable

Terminal

Connected to

Test item

Test condition

Specification

Inspection item(s)
A
Instrument cluster
Continuity
Cluster switch No.1 terminal A—Instrument cluster B
Continuity
•  Wiring harness between cluster switch No.1 terminal A and Instrument cluster terminal B
B
IG1 relay No.2
Voltage
Ignition is switched ON
B+
•  Wiring harness between cluster switch No.1 terminal B and IG1 relay No.2 terminal C
Except above
1 V or less
C
Instrument cluster
Continuity
Cluster switch No.1 terminal C—Instrument cluster AI
Continuity
•  Wiring harness between cluster switch No.1 terminal C and Instrument cluster terminal AI
D
Ground point
Continuity
Under any condition
Continuity
•  Wiring harness between cluster switch No.1 terminal D and ground point