Home

Mazdamanuals.com

DTC U3000:49 [360°VIEW MONITOR CONTROL MODULE]

id1502c7063400

Outline

System malfunction location

360°view monitor control module internal malfunction

Detection condition

• The 360°view monitor control module detects a internal malfunction for 5 s.

Fail-safe

(See DTC TABLE [360°VIEW MONITOR CONTROL MODULE (E)].)

Possible cause

• 360°view monitor control module malfunction

System wiring diagram

Not applicable

Connector diagram

Not applicable

System malfunction location	360°view monitor control module internal malfunction
Detection condition	• The 360°view monitor control module detects a internal malfunction for 5 s.
Fail-safe	(See DTC TABLE [360°VIEW MONITOR CONTROL MODULE (E)].)
Possible cause	• 360°view monitor control module malfunction
System wiring diagram	Not applicable
Connector diagram	Not applicable

Diagnostic Procedure

Step

Inspection

Results

Action

1

INSPECT 360°VIEW MONITOR CONTROL MODULE FOR MALFUNCTION

•  Clear the DTC recorded in the memory.
(See CLEARING DTC.)

•  Perform the DTC inspection for the 360°view monitor control module.
(See DTC INSPECTION.)

•  Is the same Pending DTC present?

Yes

Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error.

(See CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW [(E)].)

If the CAN communication is normal, replace the 360°view monitor control module and perform the repair completion verification.

(See 360°VIEW MONITOR CONTROL MODULE REMOVAL/INSTALLATION [(E)].)

No

Go to the next step.

Repair completion verification

VERIFY IF OTHER DTC IS DISPLAYED

•  Perform the DTC inspection.
(See DTC INSPECTION.)

•  Are any other DTCs displayed?

Yes

Repair the malfunctioning location according to the applicable DTC troubleshooting.

No

DTC troubleshooting completed.

Step	Inspection	Results	Action
1	INSPECT 360°VIEW MONITOR CONTROL MODULE FOR MALFUNCTION • Clear the DTC recorded in the memory. (See CLEARING DTC.) • Perform the DTC inspection for the 360°view monitor control module. (See DTC INSPECTION.) • Is the same Pending DTC present?	Yes	Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error. (See CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW [(E)].) If the CAN communication is normal, replace the 360°view monitor control module and perform the repair completion verification. (See 360°VIEW MONITOR CONTROL MODULE REMOVAL/INSTALLATION [(E)].)
1		No	Go to the next step.
Repair completion verification	VERIFY IF OTHER DTC IS DISPLAYED • Perform the DTC inspection. (See DTC INSPECTION.) • Are any other DTCs displayed?	Yes	Repair the malfunctioning location according to the applicable DTC troubleshooting.
Repair completion verification		No	DTC troubleshooting completed.