Home

Mazdamanuals.com

 DTC P2119 [L8, LF, L3]

DTC P2119 [L8, LF, L3]

id0102a1811600

DTC P2119

Throttle actuator control throttle body range/performance problem

DETECTION CONDITION

• The PCM compares the TP with the default TP when the ignition switch is off. If the TP is higher than the default TP, the PCM determines that there is a throttle actuator control throttle body range/performance problem.
Diagnostic support note
• This is a continuous monitor (CCM).
• The MIL illuminates if the PCM detects the above malfunction condition in the first drive cycle.
• PENDING CODE is available if the PCM detects the above malfunction condition.
• FREEZE FRAME DATA is available.
• Are any DTCs is stored in the PCM memory.

POSSIBLE CAUSE

• Throttle actuator malfunction
• Throttle valve malfunction
• PCM malfunction

Diagnostic procedure

STEP

INSPECTION

ACTION

1
VERIFY FREEZE FRAME DATA AND DIAGNOSTIC MONITORING TEST RESULTS HAS BEEN RECORDED
• Has FREEZE FRAME DATA been recorded?
Yes
Go to the next step.
No
Record the FREEZE FRAME on the repair order, then go to the next step.
2
VERIFY RELATED REPAIR INFORMATION AVAILABILITY
• Verify related Service Information availability.
• Is any related Service Information available?
Yes
Perform repair or diagnosis according to the available Service information.
If the vehicle is not repaired, go to the next step.
No
Go to the next step.
3
INSPECT THROTTLE ACTUATOR
• Inspect the throttle actuator.
• Is there any malfunction?
Yes
Replace the throttle body, then go to Step 5.
No
Go to the next step.
4
INSPECT THROTTLE VALVE
• Inspect the throttle valve.
• Is there any malfunction?
Yes
Replace the throttle body, then go to the next step.
No
Go to the next step.
5
VERIFY TROUBLESHOOTING OF DTC P2119 COMPLETED
• Make sure to reconnect all disconnected connectors.
• Clear the DTC from the PCM memory using the WDS or equivalent.
• Turn the ignition switch to the ON position (Engine off), then off.
• Is the PENDING CODE for this DTC present?
Yes
Replace the PCM, then go to the next step.
No
Go to the next step.
6
VERIFY AFTER REPAIR PROCEDURE
• Perform the "AFTER REPAIR PROCEDURE".
• Is any DTC present?
Yes
Go to the applicable DTC inspection.
No
DTC troubleshooting completed.