Mazdamanuals.com

PCM REMOVAL/INSTALLATION [L8, LF, L3]

id0140a5802400

Note

•  When replacing the PCM, perform the following:

―  PCM configuration (See PCM CONFIGURATION [L8, LF, L3].)

―  Immobilizer system-related part programming (See IMMOBILIZER SYSTEM REPROGRAM PROCEDURE [KEYLESS ENTRY SYSTEM].)(See IMMOBILIZER SYSTEM COMPONENT REPLACEMENT/KEY ADDITION AND CLEARING [WITH ADVANCED KEYLESS SYSTEM].)

1.  Disconnect the negative battery cable.

2.  For R.H.D., perform the following procedures.

(1)  Remove the front side trim (left-side).

(2)  Partially peel back the flower covering.

3.  Remove in the order indicated in the table.

4.  Install in the reverse order of removal.

R.H.D.

am6zzw00011888

1	PCM cover No. 1 (See Set Bolt Removal Note.) (See Set Bolt Installation Note.)
2	PCM cover No. 2
3	PCM connector
4	PCM

L.H.D.

am6zzw00011889

1	PCM connector
2	PCM

Set Bolt Removal Note

1.  Using a chisel and a hammer, cut a groove on the head of the set nut/bolt so that a screwdriver can be inserted.

2.  Loose the set nut/bolt using an impact screwdriver or pliers.

am6zzw00011890

Set Bolt Installation Note

1.  Install a new set nut/bolt and tighten it until the neck of the nut/bolt is cut.

am6zzw00011891