• Since battery acid is toxic, be careful when handling the battery.
• Since battery acid is highly corrosive, be careful not to allow it to contact clothing or the vehicle.
• In case battery acid contacts skin, eyes, or clothing, flush it immediately with running water. Especially if the acid gets in the eyes, flush with water for more than 15 min and get prompt medical attention.
Electrolyte specific gravity
1. Measure the electrolyte specific gravity using a hydrometer.
Battery electrolyte specific gravity [20 °C {68 °F}]
1.22—1.29
Battery voltage
1. Inspect the battery as follows:
Step
Inspection
Action
1
Measure the battery positive voltage.
12.4 V or more
Go to Step 3.
Less than 12.4 V
Go to the next step.
2
Quick charge for 30 min and recheck voltage.
12.4 V or more
Go to the next step.
Less than 12.4 V
Replace the battery.
3
Using the battery load tester, apply load current (see battery load test current) and record battery voltage after 15 s. Is voltage more than specification?
Yes
Normal
No
Replace the battery.
Battery load test current
95D31L (64): 250 A
115D31L (70): 320 A
Standard specification
Battery temp. (°C {°F})
Minimum voltage (V)
4 {39}
9.3
10 {50}
9.4
16 {61}
9.5
21 {70}
9.6
Parasitic Draw
1. Verify that the ignition is off (key has been removed) and that all doors are closed.
2. Disconnect the negative battery cable.
3. Connect the tester between the negative battery terminal and negative battery cable, leave the battery undisturbed for 15 min., and then measure the parasitic draw.
• If not within the specification, measure the parasitic draw while removing the fuses one by one from the inside of the main fuse block and the inside of the fuse block.
Note
• If the battery is not left undisturbed for 15 min., the tester will indicate a high value (approx. 300 mA).
• If the key or any electrical accessory is operated within approx. 15 min. after the tester is connected, the battery must be left undisturbed for approx. 15 min. from that point.
Caution
• Operating electrical loads while the parasitic draw is being measured can damage the tester.
Note
• For the vehicles with the immobilizer system, periodically shifts synchronization of the security light flashing. Therefore, 45 mA (0.1 s) current is supplied when the security light is illuminated, and 25 mA (2 s) current is supplied when the security light is not illuminated. In addition, the measuring instrument, which shows the average value, indicates around 30 mA.
Battery parasitic draw (When the ignition is off (key is removed), all doors and the bonnet are closed.)
Vehicles with immobilizer system: 25—45 mA
Vehicles without immobilizer system: 30 mA or less
4. Inspect and repair wiring harnesses and connectors of the fuse where the current has decreased.