|
STEP
|
INSPECTION
|
ACTION
|
|
1
|
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
• Has FREEZE FRAME PID DATA been recorded?
|
Yes
|
Go to next step.
|
|
No
|
Record FREEZE FRAME PID DATA on repair order, then go to next step.
|
|
2
|
VERIFY RELATED REPAIR INFORMATION AVAILABILITY
• Check for related Service Bulletins and/or on-line repair information availability.
• Is any related repair information available?
|
Yes
|
Perform repair or diagnosis according to available repair information.
• If vehicle is not repaired, go to next step.
|
|
No
|
Go to next step.
|
|
3
|
INSPECT TFT SENSOR VOLTAGE
• Connect voltmeter to TCM terminal 1F.
• Turn ignition key to ON (engine OFF).
• Is TCM terminal voltage 1.55 V?
|
Yes
|
Go to next step.
|
|
No
|
Go to Step 6.
|
|
4
|
VERIFY CURRENT INPUT SIGNAL STATUS - IS CONCERN INTERMITTENT OR CONSTANT?
• Start engine.
• Drive vehicle at 60 km/h {37 mph} or above for 10 minutes or more.
-
- ATF 20 ° C {68 ° F}: 1.55 V
-
- ATF 60 ° C {140 ° F}: 0.7 V
• Does TCM terminal voltage change?
|
Yes
|
Go to Step 6.
|
|
No
|
Go to next step.
|
|
5
|
INSPECT TERMINAL CONDITION
• Turn ignition key to OFF.
• Disconnect terminal component No.2 (8-pin).
• Inspect terminals for corrosion.
• Are terminals okay?
|
Yes
|
Replace TFT sensor, then go to next step.
|
|
No
|
Repair or replace terminals, then go to next step.
|
|
6
|
VERIFY TROUBLESHOOTING OF DTC P0711 COMPLETED
• Make sure to reconnect all disconnected connectors.
• Clear DTC from memory using WDS or equivalent.
• Decrease ATF temperature to 20 ° C {68 ° F} or below.
• Drive vehicle at 60 km/h {37 mph} or above for 10 minutes or more.
• Is same DTC present?
|
Yes
|
Replace TCM, then go to next step.
|
|
No
|
Go to next step.
|
|
7
|
VERIFY AFTER REPAIR PROCEDURE
• Perform "After Repair Procedure".
• Is there any DTC present?
|
Yes
|
Go to applicable DTC inspection.
|
|
No
|
Troubleshooting completed.
|