Home

Mazdamanuals.com

i-stop OFF SWITCH INSPECTION [SKYACTIV-X 2.0]

i-stop OFF SWITCH INSPECTION [SKYACTIV-X 2.0]

 id0140hf888900

Note
•  The i-stop OFF switch is integrated with the cluster switch No.1.
•  For the i-stop OFF switch removal/installation, refer to CLUSTER SWITCH REMOVAL/INSTALLATION. (See CLUSTER SWITCH REMOVAL/INSTALLATION.)

1.  Connect the M-MDS to the DLC-2.

2.  Perform the DTC inspection for the instrument cluster. (See DTC INSPECTION.)

•  If DTCs are detected, repair the malfunctioning location according to the applicable DTC troubleshooting.
•  If DTCs are not detected, go to the next step.

3.  Access the I-STOP_OFF_SW PID using the M-MDS. (See PID/DATA MONITOR INSPECTION.)(See PID/DATA MONITOR TABLE [PCM (SKYACTIV-X)].)

Test condition
Data contents (I-STOP_OFF_SW)
i-stop OFF switch is pressed
On
Except above
Off

•  If not within the specification, replace the cluster switch No.1. (See CLUSTER SWITCH REMOVAL/INSTALLATION.)