Home

Mazdamanuals.com

DTC C1128:2A [DSC HU/CM]

DTC C1128:2A [DSC HU/CM]


 id040262008000


Outline

System malfunction location

Electric parking brake switch

Detection condition
•  While the vehicle is stopped, the DSC HU/CM detects that the activate operation or release operation of the electric parking brake switch continues for 60 s or more.
Fail-safe
Refer to “DTC Table” and “Fail-safe Function Malfunction Contents Table”.(See DTC TABLE [DSC HU/CM (E)].)
Possible cause
Caution
•  When the electric parking brake switch is continuously pulled up/pressed down for a long period, DTCs may be detected. Therefore, always verify that DTCs being detected are due to how the customer has operated the switch.
•  Electric parking brake switch malfunction
―  Electric parking brake switch is mechanically stuck
•  DSC HU/CM malfunction
System wiring diagram
Not applicable
Connector diagram
Not applicable


Diagnostic Procedure

Step

Inspection

Results

Action

1
VERIFY OPERATION CONDITION OF ELECTRIC PARKING BRAKE SWITCH BY CUSTOMER
•  Verify if the customer did the following operation.
―  While vehicle is stopped, electric parking brake switch is pulled up/pressed down continuously for 60 s or more
•  Is the operation applicable to the customer?
Yes
System is normal. (Explain to the customer that it is not necessary to continuously pull up/press down the electric parking brake switch to operate/release the electric parking brake system.)
No
Go to the next step.
2
VISUALLY INSPECT ELECTRIC PARKING BRAKE SWITCH FOR MALFUNCTION
•  Visually verify the electric parking brake switch for the following.
―  Interference with surrounding parts
―  Foreign matter penetration in movable parts
•  Is the electric parking brake switch normal?
Yes
Go to the next step.
No
Interference with surrounding parts:
•  Install the electric parking brake switch correctly.
―  If the malfunction recurs, replace the electric parking brake switch and perform the repair completion verification.
Foreign matter has penetrated movable parts:
•  Remove the foreign matter and perform the repair completion verification.
Repair completion verification 1
VERIFY THAT VEHICLE IS REPAIRED
•  Install/connect the part removed/disconnected during the troubleshooting procedure.
•  Clear the DTC recorded in the memory.
•  Perform the following procedure 3 times or more.
―  Pull up the electric parking brake switch to operate the electric parking brake.
―  Press down the electric parking brake switch to release the electric parking brake.
•  Perform the DTC inspection for the DSC HU/CM.
•  Is the same Pending DTC present?
Yes
Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error.
If the CAN communication is normal, perform the diagnosis from Step 1.
•  If the malfunction recurs, replace the DSC HU/CM, then go to the next step.
No
Go to the next step.
Repair completion verification 2
VERIFY IF OTHER DTCs DISPLAYED
•  Perform the DTC inspection.
•  Are any DTCs displayed?
Yes
Repair the malfunctioning location according to the applicable DTC troubleshooting.
No
DTC troubleshooting completed.