DTC P2855:00 [TCM (ET6A-EL, ET6AX-EL) (E)]
id0502q95786r2
Outline
System malfunction location |
Low clutch hydraulic circuit/sealing malfunction |
|
---|---|---|
Detection condition
|
• Slow engaging after operating selector lever from N to D position.
|
|
Fail-safe
|
• Not applicable
|
|
Possible cause
|
• Low clutch piston sealing malfunction
• Seal ring poor functioning
• ATF is less than specified value
|
|
System wiring diagram
|
• Not applicable
|
|
Connector diagram
|
• Not applicable
|
Diagnostic Procedure
Step |
Inspection |
Results |
Action |
---|---|---|---|
1
|
INSPECT ATF LEVEL
• Inspect the ATF level.
• Is there any malfunction?
|
Yes
|
Adjust the ATF level to the specification, then go to repair completion verification.
|
No
|
Replace the automatic transaxle.
|
||
Repair completion verification
|
VERIFY DTC TROUBLESHOOTING COMPLETED
• Perform the following procedure to ensure that the DTC has been resolved:
• Clear the DTC using the M-MDS.
(See CLEARING DTC.)
• Perform the DTC inspection using the M-MDS.
(See DTC INSPECTION.)
• Is the same Pending DTC present?
|
Yes
|
Replace the automatic transaxle.
|
No
|
DTC troubleshooting completed.
|