Home

Mazdamanuals.com

DTC U0115:00 [TCM (ET6A-EL, ET6AX-EL) (E)]

DTC U0115:00 [TCM (ET6A-EL, ET6AX-EL) (E)]

 id0502q99081r2

Outline

System malfunction location

Communication error to PCM (local CAN between TCM and PCM)
Detection condition
•  Under the following condition, the TCM cannot receive the signal from PCM (local CAN between TCM and PCM):
―  Battery voltage is 10 V or more.
Fail-safe
•  Set to TCC control.
•  Inhibits learning control.
•  Inhibits manual mode.
•  Inhibits neutral idle control.
•  Inhibits i-stop control.
•  Inhibits AAS.
•  Inhibits 5GR and 6GR.
•  Inhibits shift down when the accelerator pedal is depressed.
Possible cause
•  PCM DTC is stored.
•  PCM malfunction
•  TCM malfunction
System wiring diagram
•  Not applicable
Connector diagram
•  Not applicable

Diagnostic Procedure

Step

Inspection

Results

Action
1
RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION
•  Record the freeze frame data/snapshot data.
Note
•  Recording can be facilitated using the screen capture of the PC function.
—
Go to the next step.
2
VERIFY RELATED REPAIR INFORMATION OR SERVICE INFORMATION AVAILABILITY
•  Verify related Service Bulletins, on-line repair information, or Service Information availability.
•  Is any related information available?
Yes
Perform repair or diagnosis according to the available information.
•  If the vehicle is not repaired, go to the next step.
No
Go to the next step.
3
VERIFY PCM DTC
•  Perform the PCM DTC inspection using the M-MDS.
•  Are any DTCs present?
Yes
Go to the applicable DTC inspection.
(See DTC TABLE [PCM (SKYACTIV-G (E))].)
(See DTC TABLE [PCM (SKYACTIV-D)].)
(See DTC TABLE [PCM (SKYACTIV-X)].)
No
PCM can be considered the cause.
•  Replace the PCM and perform the repair completion verification.
Repair completion verification 1
VERIFY DTC TROUBLESHOOTING COMPLETED
•  Clear the DTC using the M-MDS.
•  Perform the following procedure to ensure that the DTC has been resolved:
―  Switch the ignition ON (engine off or on).
•  Perform the DTC inspection using the M-MDS.
•  Is the same Pending DTC present?
Yes
Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error.
(See CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW [(E)].)
If the CAN communication is normal, perform the diagnosis from Step 1.
•  If the malfunction has not been resolved, replace the control valve body.
Go to the next step.
No
Go to the next step.
Repair completion verification 2
VERIFY IF OTHER DTCs DISPLAYED
•  Perform the DTC inspection.
•  Are any other DTCs displayed?
Yes
Repair the malfunctioning location according to the applicable DTC troubleshooting.
(See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [TCM (ET6A-EL, ET6AX-EL) (E)].)
No
DTC troubleshooting completed.