Home

Mazdamanuals.com

CRANKSHAFT POSITION (CKP) SENSOR REMOVAL/INSTALLATION [SKYACTIV-X 2.0]

CRANKSHAFT POSITION (CKP) SENSOR REMOVAL/INSTALLATION [SKYACTIV-X 2.0]


 id0140hf109600

Replacement part

O-ring
 
Quantity: 1
 
Location of use: CKP sensor

Oil and chemical type

Engine oil
 
Type: Recommended oil

Caution
•  When replacing the CKP sensor, make sure that there is no foreign matter on it such as metal shavings. If it is assembled with foreign matter on it, the sensor output signal will malfunction resulting from fluctuation in magnetic flux and cause a deterioration in engine control.

1.  Turn the steering wheel to the right.

2.  Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION [(E)].)

3.  Remove front under cover No.2. (See FRONT UNDER COVER No.2 REMOVAL/INSTALLATION.)

4.  Remove the front splash shield. (See SPLASH SHIELD REMOVAL/INSTALLATION.)

5.  Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT [SKYACTIV-X 2.0].)

6.  Remove the water pipe. (See ELECTRIC THERMOSTAT REMOVAL/INSTALLATION [SKYACTIV-X 2.0].)

7.  Disconnect the CKP sensor connector.

am3zzw00034997

8.  Inspect the CKP sensor.

am3zzw00034998

9.  Install in the reverse order of removal.

10.  Add engine coolant. (See ENGINE COOLANT REPLACEMENT [SKYACTIV-X 2.0].)