Mazdamanuals.com

BAROMETRIC PRESSURE (BARO) SENSOR INSPECTION [SKYACTIV-D 1.8]

Home  id0140s1108700

PID/DATA Monitor Inspection

Note

•  Because the BARO sensor is integrated in the PCM, replacing the BARO sensor includes replacement of the PCM.

1.  Connect the M-MDS to the DLC-2.

2.  Switch the ignition ON (engine off).

3.  Measure the barometric pressure using a barometer.

4.  Verify that the measured barometric pressure and the actually measured barometric pressure (PID: BARO) input from the BARO sensor match. (See PID/DATA MONITOR INSPECTION.)(See PID/DATA MONITOR TABLE [PCM (SKYACTIV-D)].)(See PCM INSPECTION [SKYACTIV-D 1.8].)

•  If the measured barometric pressure and the actually measured barometric pressure do not match, replace the PCM. (See PCM REMOVAL/INSTALLATION [SKYACTIV-D 1.8].)