DTC P0732:00 [TCM (ET6A-EL, ET6AX-EL) (E)]
id0502q98179r2
Outline
|
System malfunction location |
2GR incorrect ratio |
|
|---|---|---|
|
Detection condition
|
• In D position, 2GR, the following phenomenon occurs:
|
|
|
Fail-safe
|
• Inhibits malfunctioning gear.
• Limits engine torque.
• Inhibits learning control.
• Inhibits manual mode.
• Inhibits neutral idle control.
• Inhibits i-stop control.
• Inhibits AAS.
|
|
|
Possible cause
|
• ATF is less than specified value
• Clutch burnt
• Shift solenoid malfunction
• ATF leakage from clutch circuit
• Control valve body malfunction
|
|
|
System wiring diagram
|
• Not applicable
|
|
|
Connector diagram
|
• Not applicable
|
|
Diagnostic Procedure
|
Step |
Inspection |
Results |
Action |
|---|---|---|---|
|
1
|
VERIFY DTC OUTPUT STATUS
• Are any the following DTCs displayed?
|
Yes
|
Go to the applicable DTC inspection.
|
|
No
|
Go to the next step.
|
||
|
2
|
INSPECT ATF LEVEL
• Inspect the ATF level.
• Is there any malfunction?
|
Yes
|
Adjust the ATF level to the specification, then go to repair completion verification.
|
|
No
|
Go to the next step.
|
||
|
Repair completion verification
|
PERFORM ON-BOARD DIAGNOSTIC TEST TO SPECIFY MALFUNCTIONING PART
• Perform the on-board diagnostic test.
• Are any DTCs present?
|
Yes
|
Repair the malfunctioning location according to the applicable DTC troubleshooting.
|
|
No
|
ATF amount in Step 2 is correct:
• Replace the automatic transaxle.
ATF amount adjusted in Step 2:
• Drive the vehicle to check it, and if there is no problem then the DTC troubleshooting is complete.
|