Mazdamanuals.com

SHOCK ABSORBING PAD REMOVAL/INSTALLATION

id091700453300

1.  Perform the headliner preparation. (See HEADLINER REMOVAL/INSTALLATION [(E)].)

2.  Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION [(E)].)

3.  Remove the following parts:

(1)  Front map light (See FRONT MAP LIGHT REMOVAL/INSTALLATION [(E)].)

(2)  Sunvisor (See SUNVISOR REMOVAL/INSTALLATION.)

(3)  Assist handle (See ASSIST HANDLE REMOVAL/INSTALLATION.)

(4)  A-pillar trim (See A-PILLAR TRIM REMOVAL/INSTALLATION [(E)].)

(5)  Front seat belt lower anchor (See FRONT SEAT BELT REMOVAL/INSTALLATION.)

(6)  B-pillar upper trim (See B-PILLAR UPPER TRIM REMOVAL/INSTALLATION.)

(7)  Rear package tray (See REAR PACKAGE TRAY REMOVAL/INSTALLATION.)

(8)  Trunk side upper trim (See TRUNK SIDE UPPER TRIM REMOVAL/INSTALLATION.)

(9)  C-pillar trim (See C-PILLAR TRIM REMOVAL/INSTALLATION.)

(10)  Shift lever knob (MTX) (See SHIFT LEVER REMOVAL/INSTALLATION [C66M-R, C66MX-R].)

(11)  Selector lever knob (ATX) (See SELECTOR LEVER COMPONENT REMOVAL/INSTALLATION.)

(12)  Upper panel (See UPPER PANEL REMOVAL/INSTALLATION.)

(13)  Console side panel (See CONSOLE SIDE PANEL REMOVAL/INSTALLATION.)

(14)  Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION.)

(15)  Front console box (See FRONT CONSOLE BOX REMOVAL/INSTALLATION.)

(16)  Cup holder (See CUP HOLDER REMOVAL/INSTALLATION.)

(17)  Side wall (See SIDE WALL REMOVAL/INSTALLATION.)

(18)  Rear console (See REAR CONSOLE REMOVAL/INSTALLATION [(E)].)

(19)  Driver-side air bag module (See DRIVER-SIDE AIR BAG MODULE REMOVAL [TWO-STEP DEPLOYMENT CONTROL SYSTEM].) (See DRIVER-SIDE AIR BAG MODULE INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM].)

(20)  Steering wheel (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION [(E)].)

(21)  Sensor cover (See SENSOR COVER REMOVAL/INSTALLATION.)

(22)  Rear vent duct No.2 (with rear vent duct) (See REAR VENT DUCT REMOVAL/INSTALLATION.)

(23)  Rear vent duct No.1 (with rear vent duct) (See REAR VENT DUCT REMOVAL/INSTALLATION.)

(24)  Rear console bracket No.1 (See REAR CONSOLE REMOVAL/INSTALLATION [(E)].)

(25)  Headliner (See HEADLINER REMOVAL/INSTALLATION [(E)].)

4.  Remove the bolt.

ac30zw00000161

5.  Set the curtain air bag module aside.

6.  Remove the clips.

ac30zw00000162

7.  Remove the shock absorbing pad in the direction of the arrows shown in the figure.

8.  Install in the reverse order of removal.